Drywall which side

Does it matter which side of plasterboard? It dosn't matter if you put the dark side inside i. Inside walls are OK, but you have to have the outside i. How hard is it to hang drywall? Drywall is heavy, awkward and hard to get into position. To make it a lot easier, pony up for a drywall lift. Next, hang the top wall row. Is there a right and wrong side to drywall? Thanks to each of you for your help! What do you mean the drywall was hung paper side out? Drywall is paper on both sides - there is no right or wrong side.

How much gap should be between sheets of drywall? Thin strips of wood can also be used as spacing guides. How far off the floor should drywall be? This allows for floor and wall expansion without cracking the drywall. Is it OK to hang drywall vertically? Hang the drywall vertically in rooms with high ceilings like foyers and open two-story living areas.

Residential: How high are the walls? For walls nine feet high or shorter, hanging the drywall horizontally has a number of benefits.

Most often I choose to hang the drywall on ceilings perpendicular to the joists. Yes, we are always trying to avoid butted seams, but an occasional butt seam is better than a ridged seam running the length of the ceiling, or sagged drywall between joists. Hanging drywall perpendicular to the overhead framing members is a good idea for several reasons:. This can be done as long as the following conditions are met:. If hung parallel, the maximum spacing is 16 inches on center. These framing spacings are only acceptable for half inch regular board when no water-based textures are being applied to the ceiling.

The lightweight drywall panels meet the same performance standards as interior ceiling boards as they are more resistant to sagging. Click to see full answer Also question is, which side of drywall tape goes out? Start at the top again and draw the knife down the other side of the corner. More compound will squeeze out. When you reach the bottom, both sides should be completely set into the compound and the corner still straight.

You can go back and do minor adjustments, but don't overwork the compound. Similarly, can both sides of drywall be painted? Yes, you can paint plasterboard directly - it's usually just paper on the outside. Moisture resisting plasterboard tends to have a foil on on side though, which probably won't take paint well. The brown side of drywall should not face out. The other side -- which can be gray, green or blue, depending on type -- should face outward. Failure to orient the drywall correctly will lead to surfaces that look rough and unfinished even when painted.

Dampen, but don't soak, the tape in a bucket of water. Wetting the tape before you embed it in the joint compound can help eliminate troublesome bubbles that show up after the joint dries. Keep a bucket of water nearby and quickly run each piece of tape through it before applying the tape to the wall. In general, paper drywall tape is slightly stronger and more versatile, but mesh tape has a more manageable learning curve and better moisture resistance.

At the end of the day, this contest comes down to personal preference: use the tape that you're most comfortable with!

The tape actually should show through the filler coat; if it doesn't, your filler coat is too thick. If your first final coat doesn't cover the tape , apply more coats, but keep them thin.

Lightly sand the area with the damaged drywall tape using a drywall sanding screen. Peel away the damaged tape and drywall compound with a putty knife. Step 3: Cut the Support and Install in the Wall. Step 4: Cut the Drywall Patch to Size. Step 6: Complete the Drywall Patch. Most common causes Probably the most common cause is that there was insufficient drywall compound applied to the taped joint or improper application.

Moisture or dampness may also cause the tape to come loose. Add a cup of water to 2 gallons of mud to make the mud slightly more pliable than the original pre-mixed mud if you're going to do any texturing with a drywall knife, such as knockdown, Spanish knife or skim coating.